Input Panel - Power Dynamics PDA SERIE Manual De Instrucciones

INPUT PANEL

1. Balanced input MIC combo XLR + 6.3mm Jack)
2. Balanced Jack 6.35 mm line input
3. Effect Level input
4. Volume control for MIC
5. 5-Band EQ to adjust the sound of the outputsignal
6. Line input for audio input source e.g. mixer, CD player, etc
7. Channel 3 Source switch MP3/Line
8. MP3 player display/panel
9. Volume control Channel 3.
10. DSP (Echo) signal level control
11. DSP (Echo) Mix and Time Parameters control
12. Master volume control
13. Power Indication. This clear green indicator will light when the amplifier is turned on.
14. Clip indication. These LED will light up when amplifier are on max power. It can occur that these LED
will lit up now and then, this is not a problem. But if it lights up continually you need to adjust the volume
down, otherwise permanent damage to equipment might occur
15. Mains Power Connector / Fuse. This main fuse secures the speaker against defects. Replace this only
with a fuse of same type and value.
16. On/Off Switch: For switching the speaker on and off. Always adjust the volume down to its minimum
before switching this speaker on.
MP3 PLAYER
A. DISPLAY: Shows MP3 information
B. USB/SD SWITCH: Use switch for playing from
USB stick or SD card
C. PLAY/PAUSE: Track play or pause mode
D. STOP: Track stop playing
E. REPEAT: Select All, Folder, One or Random
TROUBLESHOOTING
One certain method of determining if a speaker is faulty is to substitute a speaker that is known to work
correctly for the suspected problem speaker. If the "normally correct speaker" is experiencing the same
difficulties or problems as the suspected problem speaker, use the information below to isolate the problem.
No output
Possible cause / Action:
Speaker cables, Reseat all connectors, Inspect cable for damage, Inspect wire or connector for stray strand
that may short
Intermittent
Possible cause / Action:
Poor connections. While it is possible for a faulty speaker to exhibit intermittent output, it's more likely that an
output cable/connector is the problem. Reseat all connectors
Constant noise, buzzing and/or humming
Possible cause / Action:
Any constant noise originates in the amplifier, mixer, signal processing, source device in the signal devices,
or line-level wiring. Check and correct system grounding as required. Chain check for noisy sources or
electronic components. Check wiring for shielding.
Do not attempt to make any repairs yourself. This would invalid your warranty. Do not make any changes to the unit.
This would also invalid your warranty. The warranty is not applicable in case of accidents or damages caused by
inappropriate use or disrespect of the warnings contained in this manual. Tronios cannot be held responsible for
personal injuries caused by a disrespect of the safety recommendations and warnings. This is also applicable to all
damages in whatever form.
F. PREV: Play previous track
G. NEXT: Play next track
H. USB CONNECTION
For connection of a USB stick with MP3 files
I. SD CARD CONNECTION
For connection of a SD CARD with MP3 files
6 - 16