Idiomas disponibles
Idiomas disponibles
EN
•
Do not use aggressive detergents or solvents to clean the
plastic parts or handles.
•
Keep the trimmer head free of grass, leaves, or excessive
grease.
•
Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
•
Do not spray water onto the motor and electrical
components.
10.3
REPLACE THE SKID PLATE
1. Remove the screws with a Phillips Head screwdriver (not
included).
2. Replace with the new skid plate (1).
3. Tighten the screws.
10.4
REPLACE THE WHEEL
1. Remove the battery.
2. Remove the wing nut (1), washer (2), axle sleeve (3),
wheel (4), axle sleeve (3), rubber washer (5) and wheel
axle (6) orderly from the wheel assembly.
3. Replace with the new wheel.
4. Insert the wheel axle (6) through the slot (7) downward,
then put the rubber washer (5), axle sleeve (3), wheel (4),
axle sleeve (3), washer (2) and wing nut (1) orderly
through the wheel axle (6).
6
4
5
3
3
7
English
5. Tighten the wing nut (1).
11
TRANSPORTATION AND
STORAGE
Remove the battery pack from the machine before
transportation and storage.
1
11.1
MOVE THE MACHINE
When you move the machine, you must:
•
Stop the machine.
•
Remove the battery pack.
11.2
STORE THE MACHINE
•
Remove the battery pack from the machine.
•
Make sure that children cannot come near the machine.
•
Keep the machine away from corrosive agents such as
garden chemicals and de-icing salts.
2
1
•
Secure the machine during transportion to prevent
damage or injury. Clean and examine the machine for any
damage.
12
TROUBLESHOOTING
Problem
The ma-
chine does
not start
when you
push the
trigger.
10
1
2
3
4
3
5
6
WARNING
Possible Cause
Solution
No electrical con-
1. Remove battery pack.
tact between the
2. Check contact and in-
machine and the
stall the battery pack
battery pack.
again.
The battery pack is
Charge the battery pack.
depleted.
The lock-out but-
1. Pull the lock-out but-
ton and trigger are
ton and hold it.
not pushed at the
2. Pull the trigger to start
same time.
the machine.
