LG DLEX7600 E Serie Manual Del Propietário página 32

32 INSTALLATION
Installation Test (Duct Check)
Once you have completed the installation of the
dryer, use this test to make sure the condition of the
exhaust system is adequate for proper operation of
the dryer. This test should be performed to alert you
to any serious problems in the exhaust system of
your home.
• Your dryer features Flow Sense™, an innovative
sensing system that automatically detects
blockages and restrictions in dryer ductwork.
Keeping ductwork clean of lint buildup and free of
restrictions allows clothes to dry faster and reduces
energy use.
NOTE
The dryer should be cool before starting this test.
If the dryer was warmed up during installation, run
the AIR DRY cycle for a few minutes to reduce
the interior temperature.
To activate the installation test:
1
Remove the drying rack and literature, and
then close the door.
Do not load anything in the drum for this test, as
in may affect the accuracy of the results.
2
Press the Power button then immediately press
and hold both the Temp. and Signal buttons until
appears in the display.
3
Press the START/PAUSE button.
The dryer will start the test, which will last about
2 minutes. The heat will be turned on and the
temperatures in the drum will be measured.
MFL67731070_en_170711.indd 32
4
Check the display for results.
During the test cycle, monitor the Flow Sense™
display on the control panel. If no bars are
displayed, when the cycle ends, the exhaust
system is adequate. If the exhaust system is
severely restricted, the display will show four
bars. Other problems may also be shown with
error codes. Refer to the next page for error
code details and solutions.
NO BARS:
OK
Four bars indicates that the exhaust system is
severely restricted. Have the system checked
immediately, as performance will be poor.
5
End of cycle.
At the end of the test cycle,
The test cycle will end and the dryer will shut off
automatically after a short delay.
• Check the error code before you call for service
Error Possible
Code Causes
tE1 • Temperature
or sensor
tE2 failure.
• Humidity
hS sensor
failure.
• Electric
dryer power
cord is not
connected
correctly, or
house power
supply is
PS
incorrect.
or PF
or nP
• House fuse is
blown, circuit
breaker
has tripped,
or power
outage has
occurred.
FOUR BARS:
RESTRICTED
will display.
Solutions
• Turn off the dryer and
call for service.
• Turn off the dryer and
call for service.
• Check the power
supply or the
connection of the
power cord to the
terminal block. Refer
to the Connecting
Electric Dryers
section of this
manual for complete
instructions.
• Reset circuit breaker
or replace fuse. Do
not increase the fuse
capacity.
If the problem is a
circuit overload, have
it corrected by a
qualified electrician.
2017-07-11 오후 4:05:10