Danby Designer DBC117A2BSSDD-6 Manual Del Propietário página 6

OPERATING INSTRUCTIONS
DOOR REVERSAL INSTRUCTIONS
If the direction of the door swing is inconvenient, it
can be changed by following the steps below.
Note: If the appliance is placed on its back or
side for any length of time during this process,
it must be allowed to remain upright for 6 hours
before plugging in to avoid damage to internal
components.
1. Use a screwdriver to remove the hinge cover
and hinge from the right side of the chassis.
Remove the door from the chassis. Remove the
hole covers from the screw holes on the left side
of the chassis and install the upper hinge on the
left side.
2. Install the hole covers in the screw holes on the
right side of the chassis. Move the hole cover on
the top of the door from the left to the right side
to expose the hinge pin hole on the left side of
the door.
3. Remove the screws from the door handle and
move the door handle to the right side of the
door. Pre-drilled screw holes can be found on
the right side of the door.
4. Install the door into the top hinge and then
move the lower hinge from the right side of the
appliance to the left side.
Note: Before tightening the bottom hinge, ensure
that the top of the door is level with the top of the
chassis and that the rubber gasket is making a good
seal with the chassis all the way around.
1
2
3
4
5