Idiomas disponibles
Idiomas disponibles
CAUTION:
Only use genuine Makita batteries.
Use of non-genuine Makita batteries, or batteries that
have been altered, may result in the battery bursting
causing fires, personal injury and damage. It will
also void the Makita warranty for the Makita tool and
charger.
Tips for maintaining maximum
battery life
1.
Charge the battery cartridge before completely
discharged. Always stop tool operation and
charge the battery cartridge when you notice
less tool power.
2.
Never recharge a fully charged battery car-
tridge. Overcharging shortens the battery
service life.
3.
Charge the battery cartridge with room tem-
perature at 10 °C - 40 °C (50 °F - 104 °F). Let
a hot battery cartridge cool down before
charging it.
4.
When not using the battery cartridge, remove
it from the tool or the charger.
5.
Charge the battery cartridge if you do not use
it for a long period (more than six months).
ASSEMBLY
CAUTION:
Always be sure that the machine is
switched off and the battery cartridge is removed
before carrying out any work on the machine.
Assembly for blowing
Installing or removing the nozzle
Optional accessory for XBU06
Align the protrusions on the nozzle with the grooves on
the main unit, then insert the nozzle into the main unit,
and then turn it to lock it into place.
1
Fig.1
► 1. Nozzle
To remove the nozzle, perform the installation proce-
dure in reverse.
Installing or removing the garden nozzle
Optional accessory for XBU05 / ADBU05
Align the protrusions on the garden nozzle with the
grooves on the main unit, then insert the garden nozzle
into the main unit, and then turn it to lock it into place.
1
Fig.2
► 1. Garden nozzle
To remove the garden nozzle, perform the installation
procedure in reverse.
Installing or removing the long nozzle
Optional accessory for XBU05 / XBU06 / ADBU05
Install the long nozzle in the same way as the nozzle. To remove
the long nozzle, perform the installation procedure in reverse.
Installing or removing the tapered nozzle
Optional accessory for XBU05 / XBU06 / ADBU05
Attach the tapered nozzle to the nozzle, and then install
the nozzle to the main unit. To remove the tapered noz-
zle, perform the installation procedure in reverse.
Assembly for vacuuming
Installing or removing the nozzle
Optional accessory for XBU06
Align the protrusions on the nozzle with the grooves on
the main unit, then insert the nozzle into the main unit,
and then turn it to lock it into place.
Fig.3
► 1. Nozzle
To remove the nozzle, perform the installation procedure in reverse.
7 ENGLISH
1
