Idiomas disponibles
Idiomas disponibles
Power
A
Press to "wake up" the display. If the display is active, press to put the dryer into idle mode.
NOTE: Pressing Power does not disconnect the appliance from the power supply.
Start and Pause
B
Press Start to begin the cycle. NOTE: The door must be closed for the dryer to start the cycle. Pressing Pause will pause the
cycle, the Start will blink and "PAUSE" will scroll across the LCD.
To continue the cycle, press Start again. To stop the cycle, hold the button for 3 seconds.
Display and Status Lights
C
The display shows the approximate time remaining until the end of the cycle.
In addition, this display will, "scroll" the dryer status:
• PAUSE
The message "PAUSE" will scroll across the display when the dryer's cycle is paused. The cycle may be
re-started by pressing the Start button.
• door
The message "door" will be displayed when the door is opened during the dryer's cycle.
• CyCLE
The message "CyCLE" will be displayed when the clothes are dry and the dryer is recommending a
preferred cycle for the next load (see CleanSpeak™ section).
• dELAY
The message "dELAY" will be displayed when the Delayed Dry is initiated. It will be replaced with the
estimated time when cycle starts.
Cycle status lights
Shows whether the dryer is in the DRYING, DAMP, or COOL DOWN cycle.
Feature status lights indicate:
Delay Dry
Locked Controls
Clean Lint Filter
- Dryer is connected to the network and can communicate with a connected smartphone device.
A delay dry time is set.
The dryer controls are locked - will blink once if you press any button or turn the cycle knob.
Light will stay on for 15 seconds after the cycle stops.
GEAppliances.com
5
