• If screws are not properly tightened, the motor might oscillate. This
could be dangerous.
• Once the above steps are all finished, install the hanger ball onto the
down rod, insert the stop pin in the down rod and lift up the hanger
ball. Then, tighten all the screws firmly so that all the elements are
completely and securely fixed.
2.3. HANGING THE FAN TO THE MOUNTING BRACKET AND
ATTACHING THE BLADES
• Lift the fan up to the mounting bracket, insert the hanger ball in the
mounting bracket through the opening and carefully let it rest.
• Rotate the ball and make sure that the tab located in the mounting
bracket is aligned with the hanging ball's slot.
• When aligned, the fan will automatically sit on its correct position.
This will prevent rotation of the rod and fan when the unit is
operating.
2.4. REMOTE CONTROL AND WIRING INSTRUCTION
• Place the receiver through the hanging bracket and connect the
wires following the colour codes.
• Connect the push connectors from the fan to the remote control as
stated below:
ENGLISH
ENGLISH