Southland SLS20825 Manual Del Operador página 8

Idiomas disponibles

Idiomas disponibles

Assembly
• Save all instructions
CAUTION
Read, understand and follow all instructions for
assembly and operation. Failure to properly assemble
this equipment could result in serious injury to the
user or bystanders, or cause equipment damage.
UNPACKING INSTRUCTIONS
Set the shipping crate on a solid flat surface and
carefully remove the lid. Use two adults and take
all parts out of the shipping crate and inspect the
components to ensure there are no missing pieces
before starting to assemble the log splitter follow
steps 1 through 9.
CARTON CONTENTS
1
Engine and Pump assembly
2
Hydraulic Oil Tank assembly
3
Tow Bar assembly
4
Support Leg
5
Beam assembly
6
Wheel assemblies
7
Hardware pack
Owner Manual and Engine
8
Manual
9
Hub Caps and assembly tube
TOOLS REQUIRED
Rubber or Wooden Hammer
13 mm,16 mm,17 mm, 19 mm Wrenches or
Socket Wrenches
One 8 inch Adjustable Wrench and one 10 inch
Adjustable Wrench
Phillips Screwdriver
Torque Wrench (ft. lbs.)
Pliers
Questions? Call Toll Free at 1-800-737-2112
Step 1: Wheel Assembly
1. Attach the wheel (#2) to the oil tank axle (#1) using
a flat washer Ø20 (#6) and hex slotted nut M20 (#3).
The slotted nut should be tightened by hand and
then slowly tightened with a wrench only until the
side free-play is removed from the bearing assem-
bly. Rotate the wheel while tightening the nut. The
wheel should turn freely. Install the cotter pin Ø4x36
(#4) through a slot in the nut M20 (#3) and the hole
in the spindle. If necessary, the slotted nut may be
loosened slightly until a slot in the nut aligns with the
hole in the spindle.
2. Once installed, bend both ends of the cotter pin to
QTY
prevent its loss. Rotate the wheel and observe for
1
smooth and free movement. (See fig. 2)
1
WARNING
1
Installation of the cotter pin is important and required.
1
Failure to install the cotter pin can result in loss of
1
wheel retention. Always assemble using a new cotter,
2
do not reuse.
1
3. Install the axle cap (#5) on the end using rubber
1
hammer and assembly tube.
2
NOTICE
Flat washer Ø20 (#6), hex slotted nut M20 (#3) and
cotter pin Ø4x36 (#4) are not located in the hardware
kit, but are already loosely assembled in the log splitter
spindles.
Figure 2
ENG - 8
Copyright © 2017 MAT Engine Technologies, LLC
1
2
3
4
5
6
loading