Idiomas disponibles
Idiomas disponibles
F1 - Stand Alone operation
In the Stand Alone mode, the TS-2 can be used without controller. Disconnect the TS-2 from the controller
and call up the internal program (F1).
• Press the Function button and select „F1".
• Press the Up button to select "y" if you wish to enable this function or press the Down button to select "n"
if you don't.
F2 - Pan Reverse
With this function you can reverse the Pan-movement.
• Press the Function button and select „F2".
• Press the Up button to select "y" if you wish to enable this function or press the Down button to select "n"
if you don't.
F3 - Tilt Reverse
With this function you can reverse the Tilt-movement.
• Press the Function button and select „F3".
• Press the Up button to select "y" if you wish to enable this function or press the Down button to select "n"
if you don't.
F4 - Lamp on/off
With this function you can switch the lamp on or off via DMX channel 5.
• Press the Function button and select „F4".
• Select "n" if you wish to switch the lamp on and off or "y" if you wish to let the lamp shine permenantly.
F5 - Reset
With this function you can reset the device via the Control Board.
• Press the Function button and select „F5".
• Press the Up button to select "y" if you wish to enable this function or press the Down button to select "n"
if you don't.
• During the Reset, the motors are trimmed and the device is ready for use afterwards.
F6 – Music Mode
With this function you can call up sound control for the device.
• Press the Function button and select „F1".
• Press the Up button to select "y".
• Press the Function button and select „F6".
• Press the Up button to select "y".
• Press the Enter button to save.
Master/Slave-Operation
The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
Procedure:
Step 1: In order to select MASTER / SLAVE, unscrew the fixation screws of the service lid on the housing
and remove it.
Step 2: For Master operation, set the dipswitches 1, 2 to OFF.
For Slave operation, set the dipswitches 1, 2 to ON.
Step 3: Replace the service lid and tighten the screws.
DMX-controlled operation
You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. In order to call up the different features, you first have to ignite the lamp
(control channel 5, DMX-value 255).
25/52
51785765_V_1_2.DOC
