Idiomas disponibles
Idiomas disponibles
Abnormal combustion:
K
•
The flame is yellow and blue In this case take appropriate measures.
This heater cannot be switched on continuously for more than 36 hours. After 36
hours it stops automatically, even if the tank has been refilled within this period.
E
SETTING THE REQUIRED TEMPERATURE
If the heater is on, the required temperature can be changed using the adjustment
buttons
19
the temperature, press the - button. Each time you press the adjustment button
the temperature changes by 1ºC. The temperature can be set to a minimum of 5°C
and a maximum of 26ºC.
• If the heater is used in a small space, in a well-insulated space or if the outside
temperature is relatively high, the ambient temperature can become higher
L
than the required temperature. In this case, turn the heater off.
• The displayed temperature is the mean ambient temperature. This
temperature may not correspond with that indicated by a thermometer.
F
M
USING THE TIMER
The timer allows you to switch on the heater automatically at a preset time.
In order to switch on the timer, the correct time must have been set (refer to
Section C) and the heater should be off. Follow the procedure below:
1
Check that the time is set properly (see chapter C).
2
Press the mode button R (fig. L) until Timer and Set appear in the display.
N
3
Press the ( - ) or ( + ) buttons S to set the required activation time for the
heater. Press the ( + ) button to go forwards and the ( - ) button to go backwards.
The time will change in one minute steps each time you press one of these 2
buttons. The time on the display will change in ten minute steps if you keep
the button pressed (fig. M).
4
Press the ON / OFF buttons
It is not necessary to press this button if the heater is on.
5
Press the timer button Q. The indicator goes out. The time indicator will light
up and the timer is set.
Take care not to press the ON / OFF button
will reset the timer.
6
The heater turns on at the time chosen.
• To cancel the timer, press the ON / OFF button
out).
• Set the timer and the clock again after a power cut.
• In case of an earthquake, or shocks, code E01 will appear in the display. Reset
the error and repeat from point 4 to set the timer again.
(fig. K). To increase the temperature, press the + button. To decrease
to turn the heater on (the indicator will light up).
20
again after setting the timer, this
20
(the timer indicator goes
20
4
69
