Idiomas disponibles
Idiomas disponibles
1
2
3
4
WARNING:
•
Guide the power cord whilst it rewinds onto the reel, since otherwise the cord could become tangled or
the plug could strike the back of the appliance. Take hold of the power cord near the mark, and allow it
to gently slide through your fingers back into the appliance (see figure 5).
OPERATION
1. Push the hose into the hose connection on
the motor unit (see figure 1). To remove the
hose, push the two buttons and pull it out of
the hose connection.
2. The power cord has a yellow (B) and red (A)
mark (see figure 2). Pull out the cord to the
yellow mark.
3. Slide the hose handle into the telescopic tube
(see figure 3A).
4. Press the button on the telescopic tube and
keep it pressed in; you can then extend or
retract the tube to the required length (see
figure 3B).
5. Press the foot button on the nozzle to set the
combi nozzle for use on hard or soft surfaces,
(see figure 3C). For use on hard surfaces,
press the foot button on the combi nozzle to
extend the brushes. Lift the button for use on
soft surfaces.
6. Put the plug in the wall socket, and press the
On/Off switch. To switch off the appliance,
press the On/Off switch again (4).
7. The appliance is now ready for use. You
can move the vacuum cleaner while you are
cleaning by pulling on the hose grip. You can
lift the appliance with the vacuum cleaner's
handle (3).
8. You can adjust the vacuum suction with the
vacuum suction control (see figure (5). It is
advisable to reduce the vacuum suction when
cleaning upholstered furniture and curtains.
This will prevent the fabric from being sucked
into the nozzle.
9.
In addition, you can use the electronic suction
power regulator (18) to determine how much
suction power you want to use.
WARNING:
•
Never pull out the power cord beyond the red
mark (A). This could damage the power cord.
•
For wooden flors we reccomend you to use
the special hard floor brush
OPERATION - STORAGE AFTER USE
1. Remove the plug from the wall socket.
2. Press the rewind button and keep it pressed
in; the power cord will automatically rewind
onto the reel.
3. An attachment slot for the combi nozzle is
fitted to the back of the vacuum cleaner.
This avoids the need to dismantle the
vacuum cleaner after use; you can store the
assembled appliance and retrieve it again
quickly when you need it.
31
EN
