Idiomas disponibles
Idiomas disponibles
Mobile or manufactured home
8
installation
•
Installation MUST conform to local codes or, in the absence
of local codes, with the AMERICAN NATIONAL STANDARD
FOR MOBILE HOME), ANSI/NFPA NO. 501B.
•
The appliance MUST be vented to the outdoors with the
termination securely fastened to the mobile home
structure.
•
The vent MUST NOT be terminated beneath a mobile or
manufactured home.
•
The vent duct material MUST BE METAL.
•
Do not use sheet metal screws or other fastening devices
which extend into the interior of the exhaust vent.
•
See section 2 for electrical connection information.
Fixed and bedroom or Closet
9
installation
1"
0"
1-4"
(2.54 cm)
(0 cm)
(2.54- 10.16 cm)
•
If your appliance is approved for installation in a bedroom
or closet, it will be stated on a label on the back of the
appliance.
•
Dryer MUST be vented to the outdoors. See the EXHAUST
INFORMATION section.
•
Do not install this appliance with less than the minimum
clearance shown above.
•
Closet must have venting to the outdoors, in order to
prevent the accumulation of gas in the event of loss of the
gas supply.
•
No other fuel-consuming appliance should be installed in
the same closet.
Consideration must be given to provide adequate
clearance for installation and technical service.
Caution:
Do not install this appliance in a closet
with a solid door.
Installation instructions
0"
(0 cm)
1"
(2.54
cm)
Door ventilation opening (27" models)
A minimum of 120 square inches (774 cm
divided at top and bottom, is required. Air openings are required
to be unobstructed when a door is installed. A louvered door
with air openings for the full length of the door is acceptable.
27" model
When louvers or registers are placed in door openings, the air
openings must be equal yo 120 square inches (774 cm
Bathroom or bedroom installation
10
•
This appliance must be vented to the outdoors. See exhaust
information in section 6 and 7.
•
The installation must conform with local codes or, in the
absence of local codes, with the NATIONAL ELECTRICAL CODE,
ANSI/NFPA No. 70 of the United States.
21
) of opening, equally
2
60 square inches
(387 cm
)
2
60 square inches
(387 cm
)
2
).
2
