Idiomas disponibles
Idiomas disponibles
INSTALLATION
NOTICE: Do NOT tilt the machine. Tilting could allow oil to flow out
of the pump and cause damage to the machine.
NOTICE: Using a voltage other than the nameplate rated voltage will
cause damage to the unit. Incorrect voltage, modification
to the power cord or electrical components can damage
unit and will void the warranty.
NOTICE: Running the machine without oil or insufficient oil will
damage the machine and void the warranty.
1. Remove all packing material and tape, as well as any protective
plastic from the equipment.
2. Clean any glue residue left by the plastic or tape.
3. Place the vacuum pack machine on a flat, level surface.
4. Check the oil gauge window at the back of the machine. Verify the
oil level is between the minimum and maximum fill lines.
5. Plug the power cord into a grounded electrical outlet that matches
the nameplate rated voltage.
6. Run the Pump Conditioning program. See Run the Pump
Conditioning Program on page 4 in this manual.
FEATURES AND CONTROLS
A
B
D
E
A
Lid
B
Chamber
C
Sealing Bar
D
Control Panel
E
Lid Retainer
F
Seal Pad
2
C
Vacuum Packing Machine with 12" Sealing Bar Operator's Manual
H
F
A
B
A On/Off Button
B Oil Cleaning Program Button
C Function LEDs
D Decrease/Cancel Button. Decreases vacuum pressure, vacuum
plus or seal time. Also cancels the cycle.
E Vacuum Gauge. A value of -1 bar is equivalent of 99% vacuum.
F Increase/Stop Button. Increases vacuum pressure, vacuum plus
or seal time. Also stops the vacuum.
G Display
H Function Select Button. Selects vacuum, vacuum plus or seal
functions.
G
F
C
D
E
