Idiomas disponibles
Idiomas disponibles
NOTE:
1. Never mix gasoline and oil directly in the Hedge Trimmer fuel tank.
CAUTION!
1. Do not use National Marine Manufacturerʼs Association (NMMA) or BIA certified oils. This type
or 2-cycle engine oil does not have the proper additives for air-cooled, 2-cycle engines and
can cause engine damages.
2. Do not use automotive motor oil. This type of oil does not have the proper additives for air-
cooled, 2-cycled engines and can cause engine damage.
THE CUTTING BLADES
CAUTION-DO NOT TOUCH THE SHARPENED EDGES OF THE CUTTING
BLADES. THE CUTTING BLADES ARE EXTREMELY SHARP AND
DANGEROUS AT ALL TIMES. ALWAYS WEAR GLOVES TO HELP PROTECT
YOUR HANDS AND FINGERS FROM INJURY.
Adjusting the cutting blades are not necessary for model HT233D and HT233DL.
Turn the screw until snug, and fasten with the nut. blades. Blades that are too loose may
vibrate, and will not provide a clean, smooth cut.
uPPer Blade
loWer Blade
ROTATIONAL REAR HANDLE
Rear handle is adjustable to five different positions by pulling the lock lever and turn the
rear handle. Pull the lock lever directly in line with the handle (following the arrow in fig),
then turn the rear handle.It is extremely important that the handle is completely located
and correctly locked in the selected position.
Do not adjust the rear handle to any other position
than specified five positions.
(Throttle lever does not work when the rear handle is unlocked)
Stop the engine before change the rear handle position.
Make sure the rear handle is locked before start the engine.
During operation, hold the rear handle with upright regardless
the blade direction.
Select the proper handle position to be always sure of a safe
and secure operating position.
English
nut
guide Bar
WaSher
SCreW
nutS
SCreWS
｜ 15 ｜
LOCK LEVER
