Jonsered LM2146CA Li58-52 Manual De Usuario página 14

LED screen
Product stops operating and all
four battery capacity LED's flash,
no other LEDs come on.
Product stops operating and the
power button flashes while the bat-
tery capacity LED's continue to
show the current state of charge
• Keep equipment safe during transportation to
prevent damage and accidents.
• For storage, remove the safety key and keep
equipment in a locked area away from children and
persons that are not approved.
• For storage, keep the product and equipment in a
dry and frost-proof area.
• When loading or moving the product, do not go more
than the maximum recommended operation angle of
15 degrees.
• Clean the product. For more information, see
clean the product on page 12 .
Cutting motor
14
Possible faults
Battery pack is loose in
the powerhead and no
longer makes good con-
tact, battery pack is too
warm, or cold or other in-
ternal battery error
Cutting chamber is clog-
ged with grass, motor con-
troller is too warm, or mo-
tor fault
TRANSPORTATION AND STORAGE
TECHNICAL DATA
unit
Possible steps
1. Stop the product.
2. Remove battery pack from product and press
the indicator button on the battery pack to
show the error code. The LED's on the battery
pack come on and show an error code.
3. Read the included battery manual for a list of
related LED error codes for possible faults and
procedures.
If the battery pack does not show an error after
pressing the indicator button on the battery pack
and only displays the state of charge, the battery
pack may have come loose in the powerhead dur-
ing operation. Install the battery pack correctly into
the powerhead until a click is heard.
1. Stop the product.
2. Remove the battery pack and turn the product
on its side with the user control interface point-
ing up.
3. Examine the blade, blade bolt, blade assem-
bly, motor and motor base for damage. Clear
all grass from the bottom of the machine and
examine for clogs.
4. Install the battery pack and follow the starting
procedure to start the machine.
If the error continues to show, let the product cool
down. The motor controller may be too warm for
operation. If the error continues to show, speak to
an approved service center.
• Lubricate the product.
• Tighten bolts and nuts.
• Replace or repair damaged components.
• Touch up all rusted or damaged paint surfaces.
Sand lightly before painting.
• Use the correct protective cover on the product that
does not keep moisture. Do not use plastic because
it cannot breathe, lets condensation collect and
causes corrosion on the product.
• Always remove the battery pack prior to
To
transportation or storage.
LM2146C Li58-52
(58VBKJN46C)
LM2146CA Li58-52
(58VBKJN46CR)
851 - 003 - 23.10.2018