EN
HOW TO USE
This lamp is fully protected against dust and splashing water. It is intended for indoor and out-
door use. The charger is designed for indoor use ONLY away from moisture. Not to be charged
CHARGING THE PRODUCT FOR THE FIRST TIME
Press « ON/OFF » button on the base of the lamp to switch off
•
the LED before charging.
•
Connect the adapter to the charging socket in the base
of the lamp. Then plug the charger in. The charging light
will be red.
•
For the first recharge, the lamp must remain on charge for
8 hours. Subsequently the battery will take approximately 6
hours to recharge.
LED BEHAVIOR
•
RED : charging.
•
LED off : battery charged OR adapter not plugged.
USING THE LAMP
Simply press the « ON/OFF » switch to light up, switch off and change the intensitie of the lamp.
•
To light up : press the switch button once.
•
To change intensity press again (3 light intensities).
•
Press again to turn off the lamp.
CLEANING
•
Clean the lamp with a damp cloth. Do not use detergents or any other chemical products as they could
damage the lamp's cover.
•
Do not expose the charger to water.
ELECTRICAL DATA
CHARGER :
100~240V AC, 50–60 Hz — 7,5V DC, 600mA
BATTERY :
Li-Po, 3,7V, 1000mAh
12
outdoors.
13/11/2019