Features
The EX6000EQ offer 1 channel with advanced individual equalization features for Bass, Mid Bass and Mid High, plus the
traditional Level, High Pass and Low Pass features. Its Full Range frequency response from 10Hz to 15KHz allows the
installation of Subwoofers, Woofers, Drivers and Twitters.
Before Installing
Read this manual carefully before installing the amplifier. You must follow the instructions for the product's installation
and connections to guarantee optimal performance. If you have any questions, get in touch with us. Before using the
amplifier, always follow these guidelines:
• Make sure the appliance is switched off before adding or removing any connections. This prevents possible damage to
the equipment connected to the amplifier;
• Keep all cables as far away as possible from the ignition cables, electronic injection modules and starter switch since
they may cause noise interference;
• Always use good quality cables and connectors. This guarantees the sound's quality and fidelity;
• To avoid damaging the cables, make sure that they do not touch sharp metal edges.
Important: Use a 220A fuse 30 centimeters from the battery as a safety precaution.
General Description
Inputs, Outputs, and Audio Controls
1
Power and Coolers
12
VENTS: Allows for the removal of warm air from the amplifier.
1 11
12 17
INPUT (RCA INPUT): This input should receive the signal through an RCA cable connected to the output of the CD/
2
MP3 player.
LEVEL (LEVEL CONTROL): Controls the input signal level, allowing for proper control of any CD/MP3 player currently
3
on the market. It can be regulated as the following:
a) on the CD/MP3 player, play any musical signal up to 80% volume.
(Ex: If the maximum volume on the player is 45 [100%], adjust to 36 [80%]).
b) on the amplifier, beginning at the lowest LEVEL, gradually increase until the clipping LED begins to flash.
c) slowly decrease the LEVEL until the LED goes off. (see entry 9 "OVER CLIP")
6
2
3
4
5
13
19
18
20
6
7
8
9
14
15
10
11
16
17