Idiomas disponibles
Idiomas disponibles
VARIABLE SPEED
SWITCH
Your hammer drill has
a variable speed dial
on switch. The speed
is regulated by the
pressure applied to
the switch.
Variable speed is particularly useful when
starting the hammer drill. Also allows you to
set an optimal speed for any kind of job.
FORWARD/REVERSE SWITCH.
The forward/reverse switch determines the
running direction of the tool.
1. To select "forward" motion, release the
trigger switch, and push the forward/reverse
switch to the right side of the tool.
2. To select "reverse" motion, release the
trigger switch, and push the forward/reverse
switch to the left side of the tool.
WARNING: When switching speeds, make
sure to release the trigger and wait for the
hammer drill to stop.
NOTE: When you operate the tool in counter-
clockwise rotation, the switch trigger is pulled
only halfway and the tool runs at half speed.
For counterclockwise rotation, you cannot
push in the lock button.
MECHANICAL SPEED ADJUSTMENT KNOB
The mechanical speed adjustment knob allows
the user select to select an optimal speed.
• Use a Low speed for starting holes without
a center guide, to drill on metal, plastics, ce-
ramics or any other application that require a
higuer torque.
• A Higher speed is used for drilling on wood,
compound wood and for using polish or ab-
brassive accesories.
To set a lower speed with high torque, turn off
the power tool and allow the motor to com-
pletely stops and turn the knob to position 1.
To set a higuer speed
with low torque, turn
off the hammer drill
and allow the motor
to completely stops
and turn the adjust
ment knob to position 2.
12
NOTE: Make sure that the speed adjustment
knob is well positioned on 1 or 2. Do not
change speed while the power tool is still ON.
If you find difficulties when changing the gear
range, manually turn the chuck until gears are
well positioned.
FUNCTION SELECTOR
To select the percus-
sion function, place
the selector to the
left indicated with the
symbol.
To select the hammer
drill function for wood
and metal drilling, place the selector to the
right with the
symbol.
OPERATION INSTRUCTIONS
ON/OFF SWITCH AND LOCK-ON BUTTON
To start the drill:
1. To turn the tool "ON", depress the trigger
switch. Increased pressure increases the speed.
2. To turn the tool "OFF", release the trigger
switch.
CAUTION: Allow the motor to come to a
complete stop before setting the drill down.
Lock-on for continuous operation:
The trigger switch is equipped with a lock-on
button.
1. To activate the lock-on feature, squeeze the
trigger switch to turn the tool "ON", and then
depress the lock-on button. The trigger switch
is locked "ON".
2. To disable the lock-on button and turn the
tool OFF, squeeze the trigger switch again.
The lock-on button will disengage. Release the
trigger switch to turn the tool "OFF".
DRILLING OPERATION
Hold the drill comfortably, with your finger
on the trigger switch. Use the auxiliary handle
whenever possible in order to gain extra con-
trol and to prevent fatigue.
NOTE:
• Use sharp drill bits only.
• For wood, use twist-drill bits, spade bits,
power-auger bits, or hole saws.
• For metal, use high-speed, steel-twist drill
bits or hole saws.
