Idiomas disponibles
Idiomas disponibles
LED indicator status
012273
NOTE:
When the LED display goes off, the tool is turned off
•
to save the battery power. To check the remaining
battery capacity, slightly pull the switch trigger.
The LED display goes off approximately one
•
minute after releasing the switch trigger.
When the tool is overheated, the light flashes once
•
per second for one minute, and then the LED
display goes off. In this case, cool down the tool
before operating again.
When the LED display lights up and the tool stops
•
even with a recharged battery cartridge, cool down
the tool fully. If the status will not change, stop using
and have the tool repaired by a Makita local service
center.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing driver bit or socket bit
12 mm
(15/32")
001266
Use only bits that has inserting portion shown in the
figure.
Remaining battery capacity
About 50% or more
About 20% - 50%
About less than 20%
9 mm
(3/8")
1
012716
To install the bit, insert the bit into the sleeve as far as it
will go.
1
011406
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out.
NOTE:
When it is difficult to insert the bit, pull the sleeve
•
and insert it into the sleeve as far as it will go.
After inserting the bit, make sure that it is firmly
•
secured. If it comes out, do not use it.
Hook
1
012581
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw. To
remove, loosen the screw and then take it out.
9
1. Bit
2. Sleeve
2
1. Bit
2. Sleeve
2
1. Groove
2. Hook
3. Screw
2
3
