Idiomas disponibles
Idiomas disponibles
ADVICE IN CASE OF A FAILURE
PROBLEM
THE CAUSE
The safety button / restart button hasn't
come on
The gas valve is closed / The gas canis-
ter is empty
The opening or tube of the diffuser is
obstructed
There's air in the gas pipe.
The burner
doesn't light
/ the burner
The piezoelectric ignition isn't working
doesn't stay lit
A build-up of dirt around the burner
There's a loose connection between the
gas valve and the pilot light.
The gas pressure is low
The opening is obstructed
The power switch isn't set to « HIGH
FLAME » or « LOW FLAME»
The gas pressure is low
The burner
The exterior temp. is greater than 5°C
flame is weak
and the tank only fills itself to 1/4
Note: Don't
The gas hose is twisted or doubled over
use the ap-
paratus if the
exterior temp is
The power switch is completely open
less than 5°C
(« HIGH FLAME » or « LOW FLAME »)
The burner
The gas pressure is low
flame isn't
uniform
The griddle isn't on a flat surface
Note: the lower
part, 2,5cm
from the burner
There's a build-up of dirt on the burner
doesn't normal-
ly light up
Build-up of
Dirt or film on the burner or diffuser
carbon
Thick black
The burner is obstructed
smoke
19/10/2022
THE SOLUTION
Push the restart button, to start the flow of
gas.
Open the valve / Replace the gas canister
Clean the opening with a brush or a fine paint
brush
Open and purge the gas tube (keep pushing
the power switch
for 1-2 minutes or until
you can smell gas)
Use a match the light the pilot light. If it lights,
get a new ignition and replace the non-wor-
king one.
Clean the burner
Tighten the connection and check to see if
there's a leak
Attach the gas cylinder again
Clean the opening
Turn the switch to « HIGH FLAME »
Reconnect the gas cylinder
Reconnect the gas cylinder
Untwist the gas hose and check there is no
leak
Turn the button to « OFF », let the apparatus
cool down and make sure that the burners
and the holes aren't obstructed.
Reconnect the gas cylinder
Put the griddle on a flat surface
Clean the burner
Clean the burner of the diffuser
Turn the button to « OFF », let the apparatus
cool-down, clear any obstructions and clean
the exterior and interior of the apparatus
EN
31
