Idiomas disponibles
Idiomas disponibles
Problems
The door seals are not
watertight.
The appliance does not cool
down enough.
The food is too warm.
The compressor does not start
immediately after changing the
temperature setting.
There is water at the back of
the appliance or on the shelves.
If the information in this table does not help you resolve your specific problem, do not attempt to
repair the appliance yourself. Contact your retailer's after-sales department.
IMPORTANT: repairs to your appliance should only be
performed by qualified service technicians. Improper repairs
can lead to hazards for users and are not covered by the
Possible causes
The door seals are dirty.
Perhaps you just reversed the
direction that the door opens.
The temperature is not set
correctly.
The door stayed open for a
long time.
A large amount of hot food has
been placed in the appliance in
the past 24 hours.
The appliance is located near a
heat source.
This is normal, it is not a
malfunction.
The drain hole for the defrost
water is blocked.
warranty.
Solutions
Clean them with water
and a soft sponge.
Carefully heat the leaking
seal sections with a hair
dryer (set to cool). At the
same time, correct the
position of the door seal
with your hand.
Please refer to the
paragraph "Setting the
temperature".
Do not open the door
longer than necessary.
Temporarily set the
thermostat to a cooler
temperature. Avoid
overloading the inside of
the refrigerator.
Please refer to the
paragraph "Place of
installation".
The compressor will start
after a while.
Refer to the paragraph
"Cleaning and
maintenance".
37
