Denver DAB-23 Manual De Instrucciones página 5

Idiomas disponibles

Manual tuning

1. To select manual tuning, press and hold the SELECT button until the display shows "Manual

tune". (F6)

2. Press the UP or DOWN button to move through the DAB channels, on the top half of the display will

show "5A to 13F" and their associated frequencies. When your radio locates a station group (ensemble

/ multiplex) on one of the DAB channels, the name of the station group will appear on the bottom half of

the display. (F7)

3. To enter the ensemble/multiplex, press the SELECT button, the top half of the display will show the first

station in the ensemble/multiplex.

4. Press the UP or DOWN button to see what stations are present on the found ensemble / multiplex,

when you have located your desired station, press the SELECT button, and at the same time, you will

also exit from the manual tuning mode.

Auto select on / off

You can explore the found stations by pressing the UP or DOWN button, if the auto select is "ON", the

station will be automatically selected when the button is released, and the name of the station will be

displayed. If the auto select is "OFF", you have to press the SELECT button to switch to that station when

the display shows your desired station, otherwise it will revert back to the original station after 4 seconds.

To toggle between the auto select "ON" and "OFF", press the UP or DOWN button and then quickly press

and hold the SELECT button until the display shows the "Autoselect ON" or "Autoselect OFF". (F.8) (F.9)

FM MODE

1. To select FM, press the DAB / FM button, the display will show "Switching to FM" and it will automatically

tune to the nearest station. On the top half of the display will show the station name or frequency if the

RDS is not available. (F.10) (F.11)

2. To activate auto search up, press the AUTOTUNE button, it will start scanning up the fre

quency band and stop automatically once a station has been found.

3. To activate auto search down, press and hold the AUTOTUNE button until it starts to scan down the

frequency band.

4. To activate manual search, press the UP or DOWN button.

5. To select audio mode, press the SELECT button,"Audio mode" will be displayed, again press

the SELECT button to toggle between "Auto" or "Mono" selection.

Note: The radio will automatically switch between stereo and mono mode, but you can override

this and switch this function manually which is helpful for poor signal reception.

F10

F11

UK - 4