Tools And Parts; Location Requirements; Before Installing; Product Dimensions - Whirlpool WH6010S Instrucciones De Instalación Y Manual De Uso Y Cuidado

Tools and Parts

Gather all the required tools and parts before
commencing the installation.
Read and follow the instructions provided with any of
the tools listed here.
Parts Supplied
Remove the parts from the package. Make sure that
no parts are missing.
 (4) 4.5 x 13 mm mounting screws (Under-cabinet
installation)
 (4) 5 x 45 mm mounting screws (Wall-mounted)
(4) 8 x 40 mm wall anchors (Wall-mounted)
Tools Needed
Drill

 11⁄4" (3.0 cm) bit
 1/8" (3.0 mm) bit for pilot holes
 Pencil
 Measuring tape or ruler
 Flat-blade screwdriver
 Phillips screwdriver
 Jigsaw or keyhole saw
Parts Needed
For cabinets with embedded bases:
Two 2" (5.1 cm) strips of wood. Length is

determined by gap size.
 Four flat-head screws for wood or screws for metal
with clamps and nuts (to secure the packing strips).

Product Dimensions

5

Location Requirements

IMPORTANT: Observe all applicable codes and
regulations.
 It is the installer's responsibility to comply with
installation clearances specified on the
model/serial/rating plate.
The model/serial/rating plate is located on the

inside left wall of the hood.
 Hood location should be away from strong draft
areas, such as windows, doors and strong heating
vents.
 The cabinet opening dimensions shown must be
used.
 The dimensions given provide minimum clearance.
Consult the cooktop/range manufacturer's
installation instructions before making any
cutouts.
 All openings in the ceiling or wall where the hood is
to be installed must be sealed.
 These range hoods are factory set for recirculating
installations.

Before Installing

Remove the white film from the hood.

 Remove the blue film from the aluminum filters.
 Remove any pac king items.

Electrical Wiring

6