Fixing Of Handle; Built-In Device - Bartscher 700133 Manual Del Usuario


Installation and assembly of this device in the non-stationary location (e.g. ship)
should be realized by the specialized companies/persons only, after assuring the
fulfilment of conditions necessary for safe operation of the device.

Due to energy savings make sure that the door of the device is closed during its
operation.

In case of moving the device to another location disconnect the power supply and
remove the plug from the socket. Remove all content from the device. Due to safety
reasons fix all loose elements inside. Fix the door with use of adhesive tape. The
wine cooler should be transported in the vertical position only.

5.1.3 Fixing of handle

Before the first use fix the supplied stainless steel
handle to the device door with use of screws.
Move the rubber seal on the door internal side left or
right to uncover the fixing holes. Fix the handle to the
door using supplied set of screws.
Then replace the seal in correct position.

5.1.4 Built-in device


The device can be built into a niche of the following dimensions: width 600 mm x
height 830 mm x depth at least 610 mm. Leave a free space of at least 10 cm
above the device. A cover is screwed in below the door, therefore the door is at the
height of 80 mm above the ground.

Connect the power cord to the power outlet and push the device into the niche.
- 36 -