VCR Setup
Connection 2
1. Connect the audio/video output jacks on VCR to the corresponding
2. Insert a video tape into the VCR and press PLAY on the VCR. (Refer
3. Use the INPUT SELECT button on the remote control to select AV1
Cable TV Setup
- After subscribing to a local cable TV service and installing a converter,
Connection 1
1. Select 3 or 4 with channel switch on cable box.
2. Tune the TV channel to the same selected output channel of cable box.
3. Select channels at the cable box or with the cable box remote control.
Connection
1. Connect the audio/video output jacks on Cable Box to the corre-
2. Use the INPUT SELECT button on the remote control to select AV1
3. Select channels with the cable box remote control.
12
All manuals and user guides at all-guides.com
- In Video mode, TV automatically reverts to TV mode if the CH
number
button or
buttons are pressed.
Connection 1
Set VCR switch to 3 or 4 and then tune TV to the same channel num-
ber.
input jacks on the TV. When connecting the TV to a VCR, match the
jack colors (Video = yellow, Audio Left = white, and Audio Right =
red).
to the VCR owner's manual.)
or AV2. (If connected to S-VIDEO on side panel, select the S-Video
external input source.)
you can watch cable TV programming.
- For further cable TV information, contact a local cable service provider.
2
sponding input jacks on the TV. When connecting the TV to Cable
Box, match the jack colors
(Video = yellow, Audio Left = white, and Audio Right = red).
or AV2.
F F
/
G G
R
VIDEO
L
AUDIO
AV1
Typical
Antennas
ANT IN
S-VIDEO
OUT
ANT OUT
IN
CH3
CH4
Direct
(R)
Connection
R R
VIDEO
VIDEO
L L
AUDIO
AUDIO
VIDEO
VIDEO
L L
AUDIO
AUDIO
A A V1 V1
A A V2 V2
(R) AUDIO (L)
VIDEO
TV
VCR
Cable Box
S-VIDEO
VIDEO
L
AUDIO
R
ANT. IN
AC INPUT
AV2
VCR
AUDIO
(L)
VIDEO
S-VIDEO
S-VIDEO
R R
ANT. IN
ANT
. IN
AC INPUT
AC INPUT
RF
Cable