Idiomas disponibles
Idiomas disponibles
Maintenance
Uso of the equipment
Designed for the automation of garage doors as per the general description. Not guaranteed for other uses.
The manufacturer reserves the right to modify equipment specifications without prior notice.
Important safety instructions for installation
· Before installing the panel, remove all unnecessary ropes or chains and disable any equipment such as locks that is not necessary for
the automatic operation.
· Before installing the panel, check that the door is in good mechanical condition, correctly balanced and that it opens and closes
correctly.
· Install the manual unlocking device at a height lower than 1.8m.
· Install any permanent control next to the door away from any moving part and at a minimum height of 1.5m.
· An easily accessible disconnection device must be fitted to the wiring for permanently connected equipment. It is wise for this to be an emergency switch.
· Following installation, check that the mechanism is correctly adjusted and that the automatism inverts when the door enters into
contact with an object 40mm high located on the floor. Where option 6 is turned to ON, check that the band stops and reverses over 4
cm.
· This equipment can only be handled by a specialist fitter, by maintenance staff or by a suitably trained operator.
2
· To connect the power supply and motor wiring, 2.5 mm
section terminals must be used.
· Fuses must only be handled when the appliance is disconnected from the mains.
· The instructions for using this equipment must remain in the possession of the user.
· European door normative EN 12453 and EN 12445 specify the following minimum protection and door safety levels:
- for single-family homes, prevent the door being able to come into contact with any object or limit the contact force (e.g. security edge)
and, in the event of automatic closure, a presence detector (e.g. photocell) must be added.
- for commercial and industrial use, prevent the door being able to come into contact with any object or limit
the contact force (e.g.
security edge) and a presence detector (e.g. photocell) must be added.
· This equipment complies with the electromagnetic compatibility standard in industrial environments following the recommendations:
use a screened motor cable, with screen clamped to the grounded metal panel, and be sure you have the internal EMC filter connected.
Important safety instructions for use
· Do not allow children to play with the door controls.
· Keep the remote controls out of the reach of children.
· Watch the door movement and keep people away until the door is fully open or closed.
· Precaution when operating the manual unlocking device, as the door may suddenly fall due to the bad condition of the springs or door
unbalance. Details on how to use the manual unlocking device must be provided by the manufacturer or the device installer.
· Examine the installation frequently, especially the cables, springs and supports, to detect signs of wear, damage or unbalance. Do not
use the door if repair work or adjustments are required, as this may cause damage.
· Check once a month whether the automatism inverts when the door enters into contact with an object 40m high located on the floor.
Readjust if necessary.
EU Declaration of conformity
JCM TECHNOLOGIES, S.A. hereby declares that the product VAR-R15 complies with the relevant fundamental requirements of the RED
Directive 2014/53/EU, as well as with the Machine Directive 2006/42/EC whenever its usage is foreseen; and with the 2011/65/EU
RoHS Directive.
See website www.jcm-tech.com/en/declarations
JCM TECHNOLOGIES, SA
BISBE MORGADES, 46 BAIXOS
08500 VIC (BARCELONA)
SPAIN
UM_3200436_VAR-R15_5ID_Rev01
Page 9/21
