Idiomas disponibles
Idiomas disponibles
Installation (continued)
4
Installing the 1-2- asy
Connect™
□
Route the junction box wires through a hole in
the 1-2- asy Connect™ (D).
□
Place the 1-2- asy Connect™ (D) against the
junction box.
□
When mounting to a wall, the "UP" arrow
must point upward.
□
When mounting to an eave, the "UP" arrow
must point toward the building.
□
Insert the small mounting bolt (FF) through the
1-2- asy Connect™ (D) hole located below
the threaded hole, and thread it into the center
hole of the mounting bracket (GG). Tighten the
bolt (FF) securely.
□
Firmly pull on the 1-2- asy Connect™ to verify
it is securely attached to the mounting bracket.
FF
6
Mounting the light fixture
NOTICE: The two pins on the rear of the light fixture must be
inserted into the terminal block for the light to work.
□
Align the bottom edge of the light fixture (B) with
the bottom edge of the 1-2- asy Connect™
(D). Tilt the light fixture (B) toward the 1-2- asy
Connect™ (D), making sure the light fixture (B) is
centered on the 1-2- asy Connect™ (D).
□
Tighten the large mounting bolt (EE) securely
through the center of the 1-2- asy Connect™
(D). Do not overtighten.
□
Push the rubber plug (AA) firmly into the
mounting bolt hole on the light fixture (B).
5
Making the electrical
connections
□
Insert the junction box wires into the side of
the terminal block and around the ground
screw. Tighten terminal block screws using
the mini-screwdriver (HH) and ground screw to
secure the wires.
□
□
□
GG
T
N
O
R
F
D
AA
6
Insert the white wire from the junction box
into the terminal marked "N (White)".
Insert the black wire from the junction box
into the terminal marked "L (Black)".
Connect the bare or green ground wire
from the junction box to the ground screw
(marked with "GND").
UP/Haut/Arriba
GND
Terre
Tierra
T
N
O
R
F
B
EE
D
N (White/
Blanc/Blanco)
L (Black/
Noir/Negro)
D
