Idiomas disponibles
Idiomas disponibles
Care and Cleaning
□
To prolong the original appearance, clean the light fixture with clear water and a soft, damp cloth only.
□
Do not use paints, solvents, or other chemicals on this light fixture. They could cause a premature
deterioration of the finish. This is not a defect in the finish and will not be covered by the warranty.
□
Do not spray the light fixture with a hose or power washer.
Troubleshooting
Problem
The light will not come on.
The light comes on during the
day.
The light comes on for no
apparent reason.
The lights turn off too late in the
Dusk-to-Dawn setting.
Possible Cause
□
The light switch is turned off.
□
The fuse is blown or the circuit breaker
is turned off.
□
Daylight turn-off (photocell) is in effect.
□
The circuit wiring is incorrect (if this is
a new installation).
□
The motion sensor is aimed in the
wrong direction.
□
The outside air temperature is close to
the same as a person's body heat.
□
The motion sensor may be installed in a
relatively dark location.
□
The "ON-TIME" switch is in the "TEST"
position.
□
The motion sensor may be sensing
small animals or automobile traffic.
□
The "SENS" switch is set too high.
□
The "DUALBRITE" switch is in the 3
hour, 6 hour, or dusk-to-dawn setting.
□
The outside temperature is much
warmer or cooler than a person's body
heat (summer or winter).
□
The light fixture is wired through a
dimmer or timer.
□
The light fixture may be installed in a
relatively dark location.
10
Solution
□
Turn the light switch on.
□
Replace the fuse or turn the
circuit breaker on.
□
Recheck after dark.
□
Verify the wiring is correct.
□
Re-aim the motion sensor
to cover the desired area.
□
Increase the "SENS"
setting.
□
The light fixture is operating
normally under these
circumstances.
□
Set the "ON-TIME" switch
to the 1, 5, or 20 minute
setting.
□
Decrease the "SENS"
setting or reposition the
motion sensor.
□
Decrease the "SENS"
setting.
□
The light fixture is operating
normally under these
circumstances.
□
Decrease the "SENS"
setting.
□
Do not use a dimmer or
timer to control the light
fixture. Replace the dimmer
or timer with a standard on/
off wall switch.
□
Relocate the light fixture
or use the 3 hour or 6 hour
setting.
