Idiomas disponibles
Idiomas disponibles
LUBRICATION
NOTE: This will position the mower deck in a
standard measurement position. Depending on
the type of grass being mowed or environmental
conditions, additional adjustments may be
required to get the desired cut.
Tire Pressures
All tires must be at 15 psi / 103 kPa / 1 bar.
IMPORTANT INFORMATION DO NOT add
a tire liner or foam fill material to the tires.
Excessive loads created by foam filled tires will
cause premature failures.
Only use O.E.M. specified tires.
Anti-scalp Rollers
Anti-scalp rollers are correctly adjusted when
they are slightly off of the ground when the deck
is at the desired cutting height in the operating
position. Anti-scalp rollers keep the deck in the
proper position to help prevent scalping in most
terrain conditions.
The anti-scalp rollers can be set in three
positions:
• Upper 1-1/2" to 2-1/2" grass (38 mm to 63 mm)
• Middle 2-1/2" to 4" grass (63 mm a 102 mm)
• Lower 4" to 6" grass (102 mm a 152 mm)
The rollers must be approximately 1/4" (6,5 mm)
from the ground.
IMPORTANT INFORMATION Adjust anti-
scalp rollers with the mower on a flat level
surface. To avoid deck damage, the anti-scalp
rollers must not be adjusted to support the
deck.
CAUTION! Wear eye protection when
cleaning or washing the mower.
Hardware
Check daily. Inspect the entire machine for loose
or missing hardware.
Caster Wheels
Check every 200 hours. Check that wheels rotate
freely.
Foam filled tires or solid tires will void the
warranty.
To replace, remove nut and caster bolt. Pull the
wheel out of the yoke and take care with the
spacer. Reinstall in reverse order. Tighten the
caster bolt and torque to 45 ft-lbs (61 Nm).
Cleaning
Regular cleaning, especially under the mower
deck, will increase the machine's life-span. Clean
the machine directly after use (after it is cooled),
before the debris sticks.
Do not spray water on the top of the mower deck.
Use compressed air to clean the top side of the
mower deck. Do not use a high pressure washer
or steam cleaner. Avoid spraying engine and
electrical components with water.
Regularly clean the underside of the deck with
normal water pressure. Attach the quick connect
(from the accessory packet) to any garden hose.
After mowing, snap the hose to the cleanout port
and turn on water supply.
Restart the mower and engage the blades to use
the spinning action to wash away debris. Make
sure the hose is away from the mower blades.
Do not rinse hot surfaces with cold water. Let unit
cool before washing.
25
