Technical Data - Urrea CM916 Manual De Usuario Y Garantía

• Using the hex wrench provided, loosen and
remove bolt.
NOTE: Bolt has right hand threads. Turn bolt
counterclockwise to loosen.
• Remove outer washer, outer flange, spacer,
and wheel. Do not remove inner flange or in-
ner washer. Removal of these two parts are not
required for wheel changes.
WARNING: If inner flange or inner washer
has been removed, replace both before placing
wheel on spacer and wheel arbor. Failure to do
so could cause an accident since wheel will not
tighten properly.
TO INSTALL
• Unplug the cut-off machine.
• Inspect the replacement wheel for defects
such as cracks, chipping, and correct speed rat-
ing. If defects are found or the speed rating is
not greater than 3,900 rpm, do not use. Select
another wheel.
• Clean debris from the inner washer and in-
ner flange.
• Place new wheel over spacer, then place both
on wheel arbor against inner flange.
• Clean outer flange, then align flats with flats
on wheel arbor and slide it onto arbor until it
is flush against wheel.
• Place the recessed side of the outer washer
against the arbor, then insert the hex head bolt
into the threaded end of the wheel arbor.
• Start threads and turn bolt clockwise to snug-
ly tighten.
NOTE: Bolt has right hand threads. Turn bolt
clockwise to tighten.
WARNING: Do not overtighten hex head
bolt. Overtightening can cause the new wheel
to crack, resulting in premature failure and
possible serious personal injury.
Inner washer
Wheel arbor
Inner flange
Spacer
INSPECTING THE CARBON BRUSHES
The carbon brushes in the motor are expend-
able parts. If the brushes become excessively
Cutting wheel
Outer washer
Hex bolt
Outer flange
E N G L I S H •
worn, motor trouble might occur. Therefore,
inspect the brushes periodically, and replace
them when they have become worn to the
wear limit line.
Also, keep the carbon brushes clean be so that
they will slide smoothly within the brush hold-
ers. The carbon brushes can easily be removed
after disassembling the brush caps with a slot-
ted screwdriver.
INSPECTING THE MOUNTING SCREWS
Regularly inspect each component of the
power tool for looseness. Re-tighten mounting
screws on any loose part.
WARNING: Never operate the power tool if
any components are loose, to prevent personal
injury.
STORAGE
Confirm that the trigger switch is turned OFF,
that the power plug has been removed from
the receptacle and that the lock-off button has
been removed and has been stored in a secure
place, after operation of the tool has been
completed.
When the tool is not in use, keep it stored in a
dry place out of the reach of children.
LUBRICATION
Lubricate the following sliding surfaces:
- Rotary portion of shaft.
- Rotary portion of vise.
- Rotary portion of vise-jaw.
- Quick vise.
CLEANING
Periodically remove chips and other waste ma-
terial from the surface of the power tool with
a damp, soapy cloth. To avoid a malfunction
of the motor, protect it from contact with oil
or water.

TECHNICAL DATA

VOLTAGE-FREQUENCY
NO LOAD SPEED
WHEEL CAPACITY
MAX CUTTING:
- Round hollow bar
- Square hollow bar
- Rectangle hollow bar
- Solid rod
POWER
WEIGHT
U se r's m a n ua l
220 V ~ 60 Hz
3 450 r/min
16" (400 mm)
120 mm
120 mm
120 mm
50 mm
4 HP (3 000 W)
57 kg (126 lb)
11