Idiomas disponibles
Idiomas disponibles
EN
WAREDOSE 35
1.
GETTING STARTED
1.1
WELCOME
Get ready for a whole new experience. WAREDOSE 35 has a fresh, new look and it's easier than ever to use.
WAREDOSE 35 is a Ware Wash Chemical Dispenser developed expressly for UK and AUSTRALIAN markets.
It has 3 programming modes to choose from: Probe, Probeless and Simplified (with Probe).
Probe Mode is used when utilising a Probe to set and maintain the desired level of detergent concentration in the
wash tank.
Probeless Mode for detergent works from a pre-set pump run time of your choice.
There is a setting for FILL or Initial Charge as well as a setting for TOP UP or Recharge.
Simplified mode is a patent pending feature that always restores the same conductivity detected in the system after
the initial fill. Thus, it won't be affected by daily fluctuations of water hardness, the dishmachine getting dirty or
probe reading deterioration.
WAREDOSE 35 includes the Power-Up option that forces the system to perform an Initial Charge at the power up
of the device.
This book explains how to get WAREDOSE 35 set up and where to turn for help, so you can enjoy the most
intuitive dosing system yet.
Please review this manual carefully. Pay particular attention to warnings and precautions. Always
follow good safety procedures, including the use of proper clothing, eye and face protection.
Please be sure to read entire manual and select operating mode before installation.
WHAT'S IN THE BOX
1.2
Before you start, check that your box contains the following items:
• System enclosure;
• Foot filter (2);
• Detergent Injector (1);
• Non Return Injection Valve (Rinse) (1);
• 2-wire cable, 2x1.5 type H-05 VVF 3 m for Power Supply;
• Detergent tubing, Blue PVC 4x6 mm, 1 rolls of 4 m;
• Inlet tubing for Rinse Aid, PVC 4x6 mm, 2 m roll;
• Outlet tubing for Rinse Aid, PE 4x6 mm, 2 m roll.
1.3
FEATURES
• Power Supply: 100-240 Vac @ 50/60 Hz with main switch
• Power Consumption: <40 W
• Detergent Pump Flow rate: 9 l/h
• Rinse Pump Flow rate: 1,5 l/h at 3 bar;
• Protection of the System: IP65. The gasketed enclosure on the WAREDOSE 35 is highly water resistant and the
electronics are further protected within the enclosure
• Weight: 3 kg
• Fuse: 1.25 A, 250 V
• Range of conductivity reading with conductivity probe: 0.2 – 5.0 mS (Conductivity probe to be purchased
separately)
• Dimensions: L 205 D 135 H 200 mm;
0000138112
rev. 1.0
2
