Idiomas disponibles
Idiomas disponibles
ENGLISH
Note
-
Take the robot vacuum cleaner to the charging base if the battery is low. The robot vacuum
cleaner may not turn on if the battery is very low.
-
The robot vacuum cleaner will automatically turn on when placed on the charging base.
-
The robot vacuum cleaner cannot be turned off during charging.
Installing the mixed tank. Fig. 8
-
Open the tank silicone cover, fill the tank with water carefully so water does not come out.
Make sure the silicone cover is properly closed to avoid water from leaking. Never immerse
the tank in water or other liquids.
-
Install the mop on the mop bracket.
-
To install the tank on the robot vacuum cleaner, follow the direction shown in figure 8 and
manually press the tab and push it into the correct position. You will hear it click into place
if done properly.
-
Install the mop bracket following the direction shown in figure 8.
Recommendations
-
It is not suggested to use the scrubbing function for the first-time use.
-
Do not use the mopping function if the robot vacuum cleaner is not being supervised.
-
To remove the mop bracket, press the release button and pull from it outwards.
-
Uninstall the mop bracket when the robot vacuum cleaner is charging or when not in use.
-
Add a few drops of cleaning agent to the water if necessary, as long as it is non-corrosive.
-
Using cleaning agents in excess might block water outlets.
-
To achieve perfect scrubbing, it is suggested to moisten the mop before using it.
First use:
-
Once the robot vacuum cleaner and the charging base are installed, follow these steps
before the first cleaning.
-
First, fully charge the robot vacuum cleaner. It is suggested to allow the robot to charge
overnight. When it is fully charged, it may carry out the first cleaning cycle and save the
first map. To do so, activate the Auto mode and select the Eco suction level. It is very
important to follow these instructions so that the robot vacuum cleaner recognises every
corner of your house and can carry out a complete mapping of it.
-
If your house is very large and the robot vacuum cleaner runs out of battery, it will return
to the charging base, save both complete and incomplete maps, and, once charged, it will
resume cleaning where it left off until the entire surface has been mapped. The robot
vacuum cleaner is constantly mapping, so it adapts in an individualised and personalised
way to the particularities of each house while constantly improving its map.
54
