Idiomas disponibles
Idiomas disponibles
EN
1
Dust nozzle
4. To remove the base, follow the installation
procedure in reverse.
11
OPERATION
Read all safety warnings, instructions, illustrations and
specifications provided with this power tool. Failure
to follow the warnings and instructions may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
11.1 START / STOP THE TOOL
To turn on the tool, press the lock/unlock button. The
tool turns into the standby mode. To start the tool, press
the start/stop button in the standby mode. To stop the
tool, press the start/stop button again. The tool turns
into the standby mode. To turn off the tool, press the
lock/unlock button in the standby mode.
1
English (Original Instructions)
2
2
Thumb screw
WARNING
2
1
Lock/unlock button
If the tool is left for 10 seconds without any operation
in the standby mode, the tool automatically turns off
and the lamp goes off.
You can also stop and turn off the tool by pressing the
lock/unlock button while the tool is operating.
11.2 ADJUST THE SPEED
The rotation speed of the tool can be changed by
turning the speed adjusting dial. The table below shows
the number on the dial and the corresponding rotation
speed.
1
Speed adjusting dial
Number
Speed
1
10,000 r/min
2
15,000 r/min
3
20,000 r/min
4
25,000 r/min
5
30,000 r/min
If the tool is operated continuously at low speed for a
long time, the motor will get overloaded, resulting in
tool malfunction.
When changing the speed dial from "5" to "1", turn the
dial counterclockwise. Do not turn the dial clockwise
forcibly.
10
2
Start/stop button
NOTE
NOTE
1
NOTICE
NOTICE
