Idiomas disponibles
Idiomas disponibles
11.3 LIGHT UP THE FRONT LAMP
CAUTION
Do not look in the light or see the source of light
directly.
To turn on the lamp, press the lock/unlock button. To
turn off the lamp, press the lock/unlock button again.
NOTICE
When the tool is overheated, the lamp flickers. Cool
down the tool fully before operating the tool again.
NOTE
Use a dry cloth to wipe the dirt off the lens of the lamp.
Be careful not to scratch the lens of lamp, or it may
lower the illumination.
11.4 ADJUST CUTTING DEPTH
To adjust the cutting depth, open the lock lever, then
move the tool base up or down by turning the adjusting
screw. After the adjustment, close the lock lever firmly.
1
1
Lock lever
NOTE
If the tool is not secured after closing the lock lever,
tighten the hex nut, and then close the lock lever.
1
English (Original Instructions)
2
2
Adjusting screw
1
Hex nut
11.5 USE THE TOOL WITH THE
ROUTER BASE
1. Set the tool base on the workpiece without the
router bit making any contact.
2. Turn the tool on and wait until the bit attains full
speed.
3. Move the tool forward over the workpiece surface.
Keep the tool base flush while moving the tool.
4. When cutting the edge, be sure to keep the
workpiece surface on the left side of the router bit
in the feed direction.
Before cutting on the actual workpiece, it is
recommended to make a sample cut. The proper
feed speed depends on the bit size, the kind
of workpiece, and depth of cut. Moving the tool
forward too fast may cause a poor quality of cut,
or damage to the bit or motor. Moving the tool
forward too slowly may burn and mar the cut.
When using the router shoe, the straight guide, or
the router guide, be sure to keep it on the right side
in the feed direction. This will help to keep it flush
with the side of the workpiece.
1
1
Router bit
3
Straight guide
11
NOTE
2
3
2
Workpiece
EN
