3. Locate and disconnect the OEM injector connector. Remove
the OEM Fuel Rail from the throttle body.
4. Loosen the upper screws of the rear frame and remove the
lower screws: then lift the rear frame.
5. Remove the air filter box.
6. Remove the intake duct inside the air filter box and the relative
fixing screw. Keep the original screw separately as it will not be
used in the assembly of the second GET injector kit.
WARNING: DO NOT USE A SCREWDRIVER OR SIMILAR
INSTRUMENT AS A LEVER TO PREVENT DAMAGE TO
THE COMPONENT.
7. Position the second GET
injector
support
as shown in the figure: the
highlighted part must be applied
in correspondence with the
intake duct fixing hole. Insert
the M4x25 screw supplied in
the kit into the fixing hole of
the intake duct and proceed by
temporarily fixing the second
injector support bracket with
the washer and self-locking nut
supplied in the kit.
bracket
5
Intake
manifold
interior
Air
filter
box
interior
EN