Idiomas disponibles
Idiomas disponibles
2.2 Electrical rating
220-240V ~, 50Hz. 580W. Class B. IPX5, H:0-10m
2.3 Electrical circuit
3 INSTALLATION
3.1 Before Installation
a.
Open the packing cartons to check whether the bathtub has defects, and the availability of fittings.
b.
Install the cap of switch, hand shower, faucet.
c.
Put the bathtub into a pre-determined place.
d.
The hot and cold water supply device should be located in a hiding place of bathtub body, through horse
to connect with hot and cold water connection. (If poor water it should be installed water filtrating
equipment.)
Lead the drainpipe to the preformed floor drain. Then set the bathtub into the right place. Doesn't
e.
extruding bending, chocking drain pipe, make sure the bailing smoothly.
f.
Carefully hand tighten the white drainpipe until stops. Don't over tighten. If possible, better to do it by
silicone or seal strips to avoid water leakage.
g.
Put the plug into the socket.
h.
Adjust the foot to make the bathtub at a horizontal position stabled.
i.
Be careful with the glass. Ask help to someone if needed. Use rubber hammer to knock if necessary
while installing. Don't use something hard to knock the glass, especially knock the corner of glass.
17
