Bestway SALUSPA Manual De Instrucciones página 7

• These SOFA-configuration specific flow ratings NOT be exceeded at any time the pool
is open to bathers.
• Cover/grates, when installed, shall not protrude more than 2 in. (51 mm) from the
finished surface of the pool in which the SOFA is installed.
8.
Installation Information label (Copy)
Manufacturers name: Bestway (Nantong) Recreation Corp.
Cover part number: S01
Life expectancy: 3 Years
Cover flow rating: 20 gal/min (0.00126 m
Configuration and installed orientation: Wall
Location: Spa Pool liner
Date of installation:_______________
Installer need to fill in the balance of information and give it to the pool owner, to
be kept with other important pool related documents.
Please research and download General Certificate of Conformity through
www.bestwaycorp.com
SAVE THESE INSTRUCTIONS
IMPORTANT:
smooth, flat, level and capable of supporting the weight for the entire time the SaluSpa is
installed (not on the carpet or other similar material). If the SaluSpa is placed on a surface
which does not meet these requirements, any damage caused by improper support is not
covered under the manufacturer's warranty. It is the responsibility of the SaluSpa owner to
assure the integrity of the surface at all times.
1. Indoor Installation:
Be aware of special requirements if you install the spa indoors.
• Humidity is a natural side effect with SaluSpa installation. First determine the effects of
moisture on exposed wood, paper, etc. in the proposed location. To minimize these effects,
it is best to provide plenty of ventilation to the selected area. An architect can help
determine if more ventilation is needed.
2. Outdoor Installation:
• During filling, draining or when in use, water may spill out of the spa. Therefore the SaluSpa
should be installed near a floor drain.
• Do not leave the spa surface exposed to direct sunlight for long periods of time.
WARNING: Before inserting plug into a power outlet, make sure the current rate of the
power outlet is suitable for the pump.
WARNING: Using an extension lead or multi plug adaptor with the spa heater can cause
the plug to overheat, causing damage to the equipment and surrounding items. The spa
is a class I electrical appliance and must be connected directly to a grounded socket. It is
recommended to only use a socket which is resistant to humidity and capable of high
power loading. Regularly check the plug and socket for signs of damage before using the
spa – do not use the spa if the plug or socket is damaged. If you are unsure about the
quality of the electrical supply, please consult a qualified electrician before use.
WARNING: The PRCD plug must be tested before each use to avoid risk of electric
shock.
WARNING: Do not use the pump if this test fails. For assistance, please visit the support
section on our website, www.bestwaycorp.com.
SELECTED LOCATION
Due to the combined weight of the SaluSpa, water, and users, it is
extremely important that the surface where the SaluSpa is installed is
PRCD WARNING
/s)
3
7