Identification Of Parts; Identi Cation Of Parts; Positioning The Unit; Operating The Unit - INVENTOR P2 - 25L Manual Del Propietário

IDENTIFICATION OF PARTS

Identi cation of parts

Front
Control panel
1
Panel
2
3
Water bucket
4 Water level window
Handle (both sides)
5
Rear
1 Continuous drain hose outlet
Caster
2
3
Power Cord and plug
Power cord buckle (placed in the water bucket,
4
used only when storing the unit. Installed as
shown Fig.3a))
Pump drain hose outlet(some models without)
5
6 Air outlet grille
7 Air lter
NOTE: All the pictures in the manual are
for explanation purposes only. The actual
shape of the unit you purchased may be
slightly di erent, but the operations and
functions are the same.
Accessories:(placed in the water bucket of the unit)
pump drain hose(1pc) (only for the unit with pump featrue)
power cord buckle(1pc)
Fig.2
2
3
Fig.3
female threaded end(1pc)
(on some models)
6

Positioning the unit

A dehumidi er operating in a basement will have little or no e ect in drying an adjacent enclosed
storage area, such as a closet, unless there is adequate circulation of air in and out of the area.
Do not use outdoors.
This dehumidifer is intended for indoor residential
applications only. This dehumidi er should not be used
for commercial or industrial applications.
Place the dehumidi er on a smooth, level oor strong
enough to support the unit with a full bucket of water.
Allow at least 20cm of air space on all sides of the unit
for good air circulation (at least 40cm of air space on
air outlet).
Place the unit in an area where the temperature will not
fall below 5 C(41 F). The coils can become covered with
frost at temperatures below 5 C(41 F), which may reduce
performance.
Place the unit away from the clothes dryer, heater or radiator.
Use the unit to prevent moisture damage anywhere books
or valuables are stored.
Use the unit anywhere books or valuables are stored to
prevent moisture damage.
The dehumidi er must be operated in an enclosed
area to be most e ective.
Close all doors, windows and other outside openings
to the room.

When using the unit

When rst using the dehumidi er, operate the unit
continuously for 24 hours. Make sure the plastic cover on
the continuous drain hose outlet is installed tightly and properly
so there are no leaks.
This unit is designed to operate with a working
environment between 5 ºC/41 ºF and 35 ºC /95 ºF.
If the unit has been switched o and needs to be
switched on again quickly, allow approximately
three minutes for the correct operation to resume.
Do not connect the dehumidi er to a multiple socket
outlet, which is also being used for other electrical
appliances.
Select a suitable location, making sure you have easy
access to an electrical outlet.
Plug the unit into a electrical socket-outlet with earth
connection.
Make sure the water bucket is correctly tted otherwise
the unit will not operate properly.
NOTE:
When the water in the bucket reaches to a certain
level, please be careful moving the unit to avoid it from
falling down.

OPERATING THE UNIT

40cm or
more
Air outlet grille
20cm or more
20cm or more
20cm or more
40cm or more
Fig.4a
Casters(At four points on the bottom of unit)
Casters can move freely.
Do not force casters to move over carpet,
nor move the unit with water in the bucket.
(The unit may tip over and spill water.)
7