Idiomas disponibles
Idiomas disponibles
After turning on the power supply, the unit starts operating in ventilation mode
BUTTON
Press this button to stop the appliance from operating
BUTTON
Press this button to set the high fan speed.
BUTTON
Press this button to set the medium fan speed.
BUTTON
Press this button to set the low fan speed.
BUTTON
Press this button to activate cooling and humidification.
THE TANK MUST BE FILLED WITH DEMINERALIZED WATER FOR THE APPLIANCE TO
OPERATE IN COOLER/HUMIDIFIER MODE.
Before connecting the power cord to the power outlet, add demineralized water directly to the water tank, which is located
inside the appliance, by opening the hook of the filter assembly located at the rear of the appliance. Fill the tank up to the
maximum limit indicated, it will be possible to view the water level through a transparent window, located on the front panel
of the unit.
If you want to keep the temperature of the water in the tank below the ambient temperature for a long time, in order to favor
cooling in the hottest season, add a tablet of synthetic ice supplied to the water in the tank, after having left it in the freezer
for the time necessary for its complete consolidation. Ice absorbs heat from water.
Continuous use of ice is recommended to optimize the cooling capacity.
It is possible that the first time you use it, you will notice a perfume or the water takes on a particular color: there are no
health risks.
After turning off the unit, if it is not expected to be used soon, proceed with the elimination of the water remaining in the
internal tank.
With the power supply disconnected, place a container under the lower hole, remove the cap that closes it and let the
remaining water flow out.
Always do this before putting the appliance away at the end of the season.
In this case it is also recommended to clean the tank with a dry cloth.
V 01/21
CONTROL PANEL
FILLING AND EMPTYING THE WATER TANK
12
