Idiomas disponibles
Idiomas disponibles
1 JUMPER | NORMAL MODE
The 1 Jumper method is preferred by most cabling standards because it
most accurately represents the signal loss experienced by the equipment
during operation.
EN
When testing the loss of the 2nd test cord, the cable under test and the two
connections of the cable under test are measured.
TEST CORD CONFIGURATION
VIEW
Connect test cords as shown for 1
Jumper Reference test:
Orange test cord connected during
Set Reference
8
www.trend-networks.com
TEST CORD AND FIBRE
UNDER TEST VIEW
Displays the components that
are included in the Autotest
measurement:
Fibre
connector
Orange line: Test cord that is included in
the autotest measurement
Blue line: Fibre under test
Grey line: Test cord that is not included in
the autotest measurement
Grey dot: Connectors that are not
included in the autotest measurement
Green dot: Connectors that are included
in the autotest measurement
N1/N2: Fibre number when testing two
fibres
164818
