Idiomas disponibles
Idiomas disponibles
GETTING STARTED
Ensure the software version installed on the LanTEK IV is 1.11 or higher. This
can be verified by pressing the gear icon in the upper-right corner of the
screen, then About and Software Version.
The remote software version is displayed when it is powered on and
connected to the main handset with either a copper or fibre optic cabling
link.
SC/ST/FC adapters are included with the FiberTEK IV modules, An optional
LC kit is available which includes LC adapters for the Rx ports of the
modules and SC-LC test cords for use on the Tx ports.
Optional Encircled Flux (EF) launch cables are available for use when a EF
launch is required/desired for multimode testing. EF cords are not necessary
when testing single-mode fibre.
HELP OPTIONS
LanTEK IV and AnyWARE cloud have a comprehensive on-board help which
will guide you through how to use the features. This can be accessed as
follows:
Help on the LanTEK IV
Icon on the Menu Bar
Or click Settings - Usage
Guides:
When a FiberTEK IV module is first connected
to the main handset the Set Reference screen
will appear. Set Reference is used to "calibrate"
the launch cords used during testing. Press
CANCEL to bypass and perform the Set
Reference procedure later, or press SET
REFERENCE to perform the procedure now.
Pressing SET REFERENCE will display the set
reference screen with the default settings.
Help on the AnyWARE Cloud
AnyWARE Cloud assistance can be
accessed by the Walk Me Through tab
located on the bottom right-hand side.
Depend On Us
EN
5
