EN
3
Getting started/setup
To set up the unit:
1. Place the unit on a suitable shelf or table
2. Connect the power adaptor between the unit and the mains supply.
3. To receive broadcast radio (DAB and FM), extend the telescopic antenna.
3.1
Setup wizard
When the unit is started for the first time, it runs
through a setup wizard to configure settings for
date/time and network. Once this has finished, the
system is ready to use in most modes.
Note: To change these settings later, select Menu >
System settings >. To run the setup wizard again,
select Menu > System settings > Setup wizard.
Select Yes to start the setup wizard.
If you choose No, the next screen asks if you would
like to run the wizard next time the unit is started.
The
time/date and network settings and enters the Main
Menu.
Note: If power is removed while the wizard is in
progress, the wizard will run again next time
when the unit is started.
3.1.1
12/24 hour display
To change between 12 and 24 hour display, select Set 12/24 hour and then select your
preference.
3.1.2
Time/date
The time and date can be updated manually or automatically. With auto-update, the time
and date are automatically synchronized with external clocks. Auto-update is generally
more accurate.
Auto-update
Auto-update works with data sent over DAB, FM or
the Internet. The clock is only updated when in a
corresponding mode, so it is best to select a mode
you use regularly.
DAB and FM use time signals broadcast with radio
transmissions.
Network uses a time signal sent from the Frontier
Silicon Internet radio portal when in any network-
connected mode.
1. Select Update from DAB, Update from FM, Update from Network or No update.
2. If you are updating from the network, set your time zone.
3. If your country uses daylight saving, the automatically updated time from the network
may be wrong by one hour. When daylight savings are in effect (during the winter),
turn on the Daylight savings option to rectify this.
Note that if you are updating the time from DAB or FM, the Daylight savings option
The setup wizard starts.
system
then
starts
PAG. 9
without
configuring
User Manual/Manual de Instrucciones
WELCOME
MULTIPLAYER 12 WEB