Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
ELECTRONIC MODULE
CALORIES
•Press the TARGET CALORIES key (KEY 13) and the CALORIES display (DISPLAY 5) will light up, along
with a 1s audible alert.
•Press UP / DOWN (KEY 10 or 11) to adjust the value (Figure 43) then press ENTER (KEY 19) to con rm.
•The preset CALORIES value counts down, TIME (DISPLAY 3), DISTANCE (DISPLAY 4), WATTS (DISPLAY 6),
SPEED (DISPLAY 2) and RPM (DISPLAY 1) start counting. (Figure 44)
•No input signal for 30s, console will emit 1 short beep and enter standby mode.
•Press the START (KEY 8) once to enter the PAUSE mode, an audible alert will sound for 0.5s every 30s.
All values are shown on the display and will ash every 4s. If training is stopped for 5 minutes, the audible
alert will sound for 2s and go into standby mode. Press START (KEY 8) to resume training.
•Press the STOP key (KEY 9) to end the training, the TIME display (DISPLAY 3) will show the total training
time; DISTANCE (DISPLAY 4) will display the total exercise distance; CALORIES (DISPLAY 5) will display the total
consumption during training; WATTS (DISPLAY 6), SPEED (DISPLAY 2) and RPM (DISPLAY 1) will change to
display AVG. & MAX. The HEART RATE display (DISPLAY 7) will change to display 65%, 85% MAX (Figure 21
~ 23) every 5s.
•Upon input of the heart rate signal, the HEART RATE display (DISPLAY 7) will show the user's rate. If
there is no signal, nothing will be displayed. (Figure 19~20).
• Press the TARGET TIME key to run the program.
FIGURE 41
FIGURE 42
FIGURE 43
30
FIGURE 44
