Idiomas disponibles
Idiomas disponibles
ZMod Power Motion Upholstery Sofa,
Chair & Modular Assembly Instructions
Side Mount Connectors
Join sectional units. Sectional units use a single bracket system to join the pieces together; the
bracket system is not intended to be weight-bearing. The joining bracket is positioned in the up (or
"receiving") direction when mounted on the right (as sitting) side of a unit, and in the down (or
"engaging") direction when mounted on the left (as sitting) side of a unit (F
1. Take note of the bracket direction on each unit that you are joining.
2. Align the units to be joined next to each other and align the mating brackets.
3. Starting with either the right or left arm unit and the unit next to it, slightly spread the front
corners of the two units, enough to view the joining brackets.
4. Lift the front corner of the unit with the bracket facing down, in the "engaging" position,
approximately 1" – 2" above the adjoining unit, move the unit over to close the front gap
and gently lower into place, making sure the two brackets are engaged.
WARNING
– To reduce the risk of serious injury:
• The front of the unit must be raised to engage the front bracket. Please see assistance
if you are unable to lift at least 57 pounds.
• Keep feet clear of the unit when lowering into position.
NOTICE:
To reduce the risk of product damage:
• Lift from the base rail. Do not lift from the upholstery or the bottom of the legrest.
5. Repeat these steps until all units are joined.
All modular units must be disconnected to safely move the modular group. To disconnect the
units, lift up the right arm (sitting) piece and then lift up one by one.
NOTICE:
To reduce the risk of product damage:
• Do not move the units while connected together. The purpose of the bracket system is to
connect the units and prevent them from being separated while on the floor. The bracket
system does not provide adequate structural support for the movement of connected units.
(ZMod Power Motion Upholstery Assembly Instructions Continued)
16
F
1 and 2).
igure
F
ZMod Power Motion Upholstery Sofa,
Chair & Modular Assembly Instructions
1
igure
2
igure
Joining Bracket
Positioned Facing Up
on Right Side Sitting
Joining Bracket
Positioned Facing
Down on Left Side
Sitting
17
