Idiomas disponibles
Idiomas disponibles
STACKING THE DRYER ON THE WASHER ( OPTIONAL )
ADJUST DRYER FEET
2
1. Carefully lay the dryer on its side. Use the packing
material so you don't scratch the finish on the dryer.
2. Remove the four feet from the dryer, using the wrench
shipped in the accessory bag, then remove the nuts.
Discard the nuts but reinstall and tighten the feet into
the dryer.
Dryer Bottom
Reinstall feet
3. Remove the two screws from the bottom back side
of the dryer and discard. (This is required to prevent
interference when stacking the machines.)
Dryer Bottom
24
Installation Instructions
Remove feet
Remove nuts
and discard
Dryer Bottom
Remove
two screws
from bottom
Back Side
of Dryer
REMOVE KNOCKOUTS (IF USING
3
COIN DROP PAYMENT)
1. Remove the knockout from the bottom plate of the
dryer using a hammer and flathead screwdriver with
its tip placed on the inside edge of the knockout.
Carefully remove the knockout and install the rubber
gasket from the accessory bag onto the knockout
opening. Lift the dryer upright onto its feet.
Remove
knockout
Front Side
of Dryer
2. Remove the knockout from the top panel of the
washer using a hammer and flathead screwdriver
with its tip placed on the inside edge of the knockout.
Carefully remove the knockout and install the rubber
gasket from the accessory bag onto the knockout
opening. Ensure the stackable (top) dryer and
bottom washer are level left to right and front to back.
If the unit is unlevel, adjust the feet to level the unit.
Remove
knockout
Front Side
of Washer
Install
gasket
around
knockout
opening
Dryer Bottom
Install
gasket
around
knockout
opening
Washer Top
49-3000277 Rev 0
