Idiomas disponibles
Idiomas disponibles
UNPACKING THE WASHER
Recycle or destroy the carton and
WARNING
plastic bags after the washer is
unpacked. Make materials inaccessible to children.
Children might use them for play. Cartons covered
with rugs, bedspreads or plastic sheets can become
airtight chambers causing suffocation.
NOTE: A base cover plate is wrapped in the top of the
packing material. Be careful while handling the bottom
cover.
1. Remove all packing materials. Upon opening of the
package, water drops may be seen on the plastic bag
and the drum. This is a normal phenomenon resulting
from water tests in the factory.
2. Remove anti-scratch film and tape from the washer.
INSTALL THE BASE COVER
1
Before beginning the installation,
WARNING
unplug the appliance or turn off the
circuit breaker. Pressing the Start/Pause button DOES
NOT disconnect power.
WARNING
Base Cover Kit - If the base
If you did not receive a base cover with your purchase, call
866.531.9828 to receive one at no cost.
1. Lay the package carton on the floor.
2. Slowly and carefully lay the washer onto its back on
the package carton.
Use package carton
to protect floor
3. Install base cover underneath unit by placing the
cover over the opening on the bottom and attaching
screws before operating.
Failure to do so can result in serious injury.
4. Carefully lift the washer to the upright position.
20
Installation Instructions
- Entanglement Hazard
cover is included, it will be
taped to the top packing
foam on the washer.
Install
on bottom
REMOVE SHIPPING HARDWARE
2
The washer is fitted with shipping hardware to prevent
internal damage during transportation. Shipping hardware
must be removed before using the washer.
1. Unscrew the 4 bolts with a wrench or socket. Remove
the lower 2 bolts first, then the upper two. One of the
bolts retains the power cord of the washer to prevent
operating without removing bolts. Keep the bolts and
sleeves for future use. They can be reinserted if the
unit needs to be transported.
Remove bolts
and brackets
2. After removing the 4 bolts with spacers and horizontal
brackets, release the power cord.
3. Close the 4 holes with the caps on the back of the
unit.
IMPORTANT:
• Failure to remove all shipping support hardware can
cause the washer to become severely unbalanced.
• Save all shipping support hardware for future use.
If you must transport the washer at a later date,
you must reinstall all shipping support hardware
to prevent shipping damage.
49-3000277 Rev 0
