Idiomas disponibles
Idiomas disponibles
Maintenance
WARNING
Authorised personnel for service work
Service work may only be carried out by
the HSM Customer Service or by HSM
service technicians of our contractual partners.
Lubrication of the synchronous wheels is
an exception.
The synchronous wheels must be lubricated
after 170 operating hours or with semi-annual
frequency by the operator / owner.
To lubricate the synchronous wheels,
proceed as follows:
• Switch the device off .
• Pull out the tray on the underside.
• Screw the tube containing the grease to the lub-
rication nipple.
• Squeeze the grease out of the tube.
Required amount for semi-annual:
15-20 ml/ gr.
• Push the tray in.
• Turn the device on again.
This document shredder meets the applicable harmonisation legislation of the European Union:
• Low Voltage directive 2014/35/EU
• EMC directive 2014/30/EU
• RoHS directive 2011/65/EU
The EU declaration of conformity can be requested from the manufacturer.
• Electrical Equipment (Safety) Regulations 2016
• Electromagnetic Compatibility Regulations 2016
• The Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment
Regulations 2012
The EU declaration of conformity can be requested from the manufacturer.
07/2022
Lubricate the synchronous wheels with
the following grease (recommended):
• K2K in accordance with
DIN 51502 / DIN 51825.
Position description of components
1.
Lubrication nipple
11. Disposal/Recycling
Dispose of the device in an environmentally
friendly way at the end of its service life.
• Pay attention to the currently applicable direc-
tives.
• Since the legal situation is always subject to
change, please contact your local authority at
the appropriate time.
As the manufacturer, HSM would be pleased to
advise you concerning the disposal of your old
device.
StoreEx HDS 150
english
NOTE
1
27
