YATO YT-82456 Manual De Instrucciones página 9

PRODUCT SPECIFICATION
The soldering station is an electrical device intended for soldering, binding through soldering of metal materials using zinc-lead
solders and lead-free for soft soldering. The temperature control allows for soldering of fi ne electrical and electronic elements
without risk of overheating. The correct, reliable, and safe operation of the device depends on its proper use, therefore:
Read the entire manual before the fi rst use of the device, and keep it for future reference.
The supplier shall not be liable for any damage resulting from failure to comply with the safety instructions and recommendations
specifi ed in this instructions manual.
ACCESSORIES
The product accessories are shown in the fi gure (I).
TECHNICAL PARAMETERS
Parameter
Catalogue No.
Rated voltage
Rated frequency
Rated power
Soldering iron supply voltage
Temperature
Temperature stability
Insulation class
Net weight
Tip-to-ground resistance
Tip-to-ground voltage
USB port
SAFETY INSTRUCTIONS
Irresponsible use of the equipment can cause fi re, therefore exercise caution when using the
equipment in areas where combustible materials are present; do not direct a stream of hot air
at the same spot or place the soldering iron tip to the same spot for an extended period; do
not use the equipment in an explosive atmosphere; be aware that heat may be transferred
to combustible materials out of sight; place the equipment on its stand after use and leave
it to cool down before storage; do not leave the equipment unattended when switched on.
Before starting work, make sure that the housing and the power cord and plug are not dam-
aged. In case of damage, do not proceed with work.
Children must not use this equipment. Children should not play with the equipment. Chil-
dren left unattended should not be allowed to perform the cleaning and maintenance of the
equipment. This equipment may not be used by persons with reduced physical or mental
abilities and persons with no experience or knowledge of the equipment, if not supervised or
instructed on its safe use so that the risks associated with it are understood.
The device is not designed to operate in high humidity conditions. The temperature at the
place of the device's use must be within the range of 0
must be below 70% without condensation. Do not expose the device to precipitation.
Before connecting the device to the power supply, make sure that the voltage, frequency,
and performance of the supply network correspond to the values shown on the device's
O R I G I N A L
GB
Unit of measurement
[V~]
[Hz]
[W]
[V DC]
[ C]
O
[ C]
O
[kg]
[Ω]
[mV]
C ÷ +40
O
I N S T R U C T I O N S
Value
YT-82456
220 – 240
50
75
24
200 – 480
+/- 1
I
2.1
<2
<2
5 V DC / 1 A
C, and the relative humidity
O
9