Idiomas disponibles
Idiomas disponibles
ENGLISH
Product description
The product you purchased is a cabinet designed to contain a Avel D H heat recovery unit. The instructions contained in
this manual only describe the cabinet assembly. For instructions on Avel D H, refer to the instruction booklet of this device.
Compliance
• This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be
made by children without supervision.
• These appliances are designed for use in residential and commercial properties.
Safety/Warnings
• After removing the appliance from its packaging, ensure that it is complete and undamaged. If in doubt contact a
professionally qualified electrician or VORTICE Spa. Do not leave packaging within the reach of children or infirm
persons.
• If you decide to stop using the appliance, switch it off and disconnect it from the power supply, storing it out of reach
of children and infirm
• If the appliance does not function correctly or develops a fault, contact VORTICE Spa immediately and ensure that only
original VORTICE Spa spares are used for any repairs.
• Always fix the cabinet to the wall, using M10 plugs and screws (not supplied) (fig.22).
• Do not use this appliance for functions other thant hose described in this instruction booklet.
• Do not make modifications of any kind to this appliance.
• Should the appliance be dropped or suffer a heavy blow, have it checked immediately by VORTICE Spa.
Assembly
See the figures.
NOTE: to ensure perfect sealing it is important to fasten the adhesive strip gasket in fig. 17 and all the screws in fig. 21.
NOTE: the indicated plenum P can be installed alternatively in positions P1/P2/P3. Depending on the chosen position, it
is necessary to break through the micro-welded sheets, in correspondence with the inlet holes of the plenum (P1/P2/P3)
and of the pipes (T1/T2/T3)
NOTE: the M6x42 pin must be inserted in the
persons.
ᴓ
8
14 holes
7
