Fein SuperCut Instrucciones De Manejo página 9

3 41 00 981 06 1 - Buch Seite 9 Montag, 10. November 2003 8:20 08
SuperCut
Operating instructions SuperCut.
Overview.
1 Switch
For switching ON/OFF.
2 Speed controller
Oscillation frequency selector with
electronic speed regulator.
3 Hand and machine guard
Always mount when working on the
outside of buildings.
4 Screw
For securing the tool.
5 Symbol on the cutter
Observe the information for operating
the cutter.
6 Supplied accessories
Pin-type face spanner.
Sharpening stone.
The accessories described or illustrated in
these operating instructions are not neces-
sarily included in the delivery of your power
tool.
For your safety.
Before using this power tool, read and comply with:
these operating instructions,
the enclosed safety instructions
(document number 3 41 30 054 06 1),
the relevant national industrial safety
regulations.
These operating instructions and the
enclosed safety information should be
kept carefully for later use and enclosed
with the machine, should it be passed on
or sold.
Intended use.
This device is intended:
for commercial applications in industry
and trade,
for cutting adhesive bonding, e. g. in the
vehicles sector,
for cutting out elastic sealing materials and
marble/trass joints,
for sawing thin sheet metal, wood and
plastic parts,
for sanding smaller areas, corners and
edges.
Safety instructions.
!
Risk of injury
Do not rivet or screw any name-plates or
signs onto the power tool. The protective
insulation can thereby be rendered inef-
fective. Adhesive labels are recom-
mended.
Only use an undamaged plug and cable.
Do not treat any materials that produce
any particles that are detrimental to health
(e. g. asbestos).
Danger! Tools with sharp edges can cause
injury. Always wear protective gloves.
!
Operation over a longer period can be
detrimental to health
When operating for a longer period, the
machine can cause disturbed circulation in
the hands due to the necessary vibration
caused by the machine during use. Factors
that would increase this risk are:
- operating the machine with cold hands,
- gripping the handle very tightly,
- longer use without regular pauses.
A doctor should be consulted if there are
any signs of disturbed circulation, a con-
tinuous tingling sensation in the fingers
and also in the case of regular, long peri-
ods of operation.
EN
9